Field determination of soil hydraulic and chemical transport properties

Salem A. Al-Jabri, Robert Horton, Dan B. Jaynes, Anju Gaur

Research output: Contribution to journalArticle

12 Citations (Scopus)

Abstract

Hydraulic and chemical transport properties are the major inputs in predictive models that simulate the movement of water and chemicals through the vadose zone. However, there is a lack of field measurements of such properties to verify models describing water and chemical movement through the soil. One of the objectives of this study was to use a point source method to determine simultaneously the hydraulic and chemical transport properties at multiple field locations. A second objective was to determine the spatial distribution of such properties across a field. A total of 50 field locations within a 7 × 15-m area were rapidly and simultaneously evaluated for such properties. The hydraulic properties were the saturated hydraulic conductivity (Ks) and the macroscopic capillary length (λc). The chemical transport properties were the immobile water content, expressed as a fraction of water content (θim/θ) and the mass exchange coefficient (α). The hydraulic properties were determined by applying three discharge rates from irrigation dripper lines and measuring the resultant steady-state flux densities at the soil surface beneath each emitter. The chemical transport properties were determined by applying a sequence of three conservative tracers at a steady-state infiltration rate and measuring their resident concentration in the soil. The Ks values ranged from 7.5 to 79.0 cm h-1, with a median of 27.4 cm h-1 (± 16.8). The λc values ranged from 0.03 to 13.1 cm, with a median of 2.6 cm (± 3.6). The θim/θ values ranged from 0.36 to 0.88, with a median of 0.57 (± 0.098). The α values ranged from 0.002 to 0.12 h-1, with a median of 0.034 h-1 (± 0.027). The values of the hydraulic and chemical transport parameters were found to be comparable with values reported by studies conducted on nearby field locations on similar soil. Based on semivariogram analysis, the measured properties were not spatially correlated. Because the method required only 2 days to collect data it should prove useful for future studies that require extensive field measurements of hydraulic and chemical transport properties.

Original languageEnglish
Pages (from-to)353-368
Number of pages16
JournalSoil Science
Volume167
Issue number6
DOIs
Publication statusPublished - 2002

Fingerprint

fluid mechanics
hydraulics
soil
hydraulic property
water content
soil movement
vadose zone
saturated hydraulic conductivity
chemical
tracer techniques
water
spatial distribution
irrigation
point source
hydraulic conductivity
soil surface
infiltration
tracer
methodology

Keywords

  • Hydraulic conductivity
  • Solute transport properties
  • Spatial variability

ASJC Scopus subject areas

  • Soil Science

Cite this

Field determination of soil hydraulic and chemical transport properties. / Al-Jabri, Salem A.; Horton, Robert; Jaynes, Dan B.; Gaur, Anju.

In: Soil Science, Vol. 167, No. 6, 2002, p. 353-368.

Research output: Contribution to journalArticle

Al-Jabri, Salem A. ; Horton, Robert ; Jaynes, Dan B. ; Gaur, Anju. / Field determination of soil hydraulic and chemical transport properties. In: Soil Science. 2002 ; Vol. 167, No. 6. pp. 353-368.
@article{06f5c82b8bcf41878e1cbf5f7f752bcc,
title = "Field determination of soil hydraulic and chemical transport properties",
abstract = "Hydraulic and chemical transport properties are the major inputs in predictive models that simulate the movement of water and chemicals through the vadose zone. However, there is a lack of field measurements of such properties to verify models describing water and chemical movement through the soil. One of the objectives of this study was to use a point source method to determine simultaneously the hydraulic and chemical transport properties at multiple field locations. A second objective was to determine the spatial distribution of such properties across a field. A total of 50 field locations within a 7 × 15-m area were rapidly and simultaneously evaluated for such properties. The hydraulic properties were the saturated hydraulic conductivity (Ks) and the macroscopic capillary length (λc). The chemical transport properties were the immobile water content, expressed as a fraction of water content (θim/θ) and the mass exchange coefficient (α). The hydraulic properties were determined by applying three discharge rates from irrigation dripper lines and measuring the resultant steady-state flux densities at the soil surface beneath each emitter. The chemical transport properties were determined by applying a sequence of three conservative tracers at a steady-state infiltration rate and measuring their resident concentration in the soil. The Ks values ranged from 7.5 to 79.0 cm h-1, with a median of 27.4 cm h-1 (± 16.8). The λc values ranged from 0.03 to 13.1 cm, with a median of 2.6 cm (± 3.6). The θim/θ values ranged from 0.36 to 0.88, with a median of 0.57 (± 0.098). The α values ranged from 0.002 to 0.12 h-1, with a median of 0.034 h-1 (± 0.027). The values of the hydraulic and chemical transport parameters were found to be comparable with values reported by studies conducted on nearby field locations on similar soil. Based on semivariogram analysis, the measured properties were not spatially correlated. Because the method required only 2 days to collect data it should prove useful for future studies that require extensive field measurements of hydraulic and chemical transport properties.",
keywords = "Hydraulic conductivity, Solute transport properties, Spatial variability",
author = "Al-Jabri, {Salem A.} and Robert Horton and Jaynes, {Dan B.} and Anju Gaur",
year = "2002",
doi = "10.1097/00010694-200206000-00001",
language = "English",
volume = "167",
pages = "353--368",
journal = "Soil Science",
issn = "0038-075X",
publisher = "Lippincott Williams and Wilkins",
number = "6",

}

TY - JOUR

T1 - Field determination of soil hydraulic and chemical transport properties

AU - Al-Jabri, Salem A.

AU - Horton, Robert

AU - Jaynes, Dan B.

AU - Gaur, Anju

PY - 2002

Y1 - 2002

N2 - Hydraulic and chemical transport properties are the major inputs in predictive models that simulate the movement of water and chemicals through the vadose zone. However, there is a lack of field measurements of such properties to verify models describing water and chemical movement through the soil. One of the objectives of this study was to use a point source method to determine simultaneously the hydraulic and chemical transport properties at multiple field locations. A second objective was to determine the spatial distribution of such properties across a field. A total of 50 field locations within a 7 × 15-m area were rapidly and simultaneously evaluated for such properties. The hydraulic properties were the saturated hydraulic conductivity (Ks) and the macroscopic capillary length (λc). The chemical transport properties were the immobile water content, expressed as a fraction of water content (θim/θ) and the mass exchange coefficient (α). The hydraulic properties were determined by applying three discharge rates from irrigation dripper lines and measuring the resultant steady-state flux densities at the soil surface beneath each emitter. The chemical transport properties were determined by applying a sequence of three conservative tracers at a steady-state infiltration rate and measuring their resident concentration in the soil. The Ks values ranged from 7.5 to 79.0 cm h-1, with a median of 27.4 cm h-1 (± 16.8). The λc values ranged from 0.03 to 13.1 cm, with a median of 2.6 cm (± 3.6). The θim/θ values ranged from 0.36 to 0.88, with a median of 0.57 (± 0.098). The α values ranged from 0.002 to 0.12 h-1, with a median of 0.034 h-1 (± 0.027). The values of the hydraulic and chemical transport parameters were found to be comparable with values reported by studies conducted on nearby field locations on similar soil. Based on semivariogram analysis, the measured properties were not spatially correlated. Because the method required only 2 days to collect data it should prove useful for future studies that require extensive field measurements of hydraulic and chemical transport properties.

AB - Hydraulic and chemical transport properties are the major inputs in predictive models that simulate the movement of water and chemicals through the vadose zone. However, there is a lack of field measurements of such properties to verify models describing water and chemical movement through the soil. One of the objectives of this study was to use a point source method to determine simultaneously the hydraulic and chemical transport properties at multiple field locations. A second objective was to determine the spatial distribution of such properties across a field. A total of 50 field locations within a 7 × 15-m area were rapidly and simultaneously evaluated for such properties. The hydraulic properties were the saturated hydraulic conductivity (Ks) and the macroscopic capillary length (λc). The chemical transport properties were the immobile water content, expressed as a fraction of water content (θim/θ) and the mass exchange coefficient (α). The hydraulic properties were determined by applying three discharge rates from irrigation dripper lines and measuring the resultant steady-state flux densities at the soil surface beneath each emitter. The chemical transport properties were determined by applying a sequence of three conservative tracers at a steady-state infiltration rate and measuring their resident concentration in the soil. The Ks values ranged from 7.5 to 79.0 cm h-1, with a median of 27.4 cm h-1 (± 16.8). The λc values ranged from 0.03 to 13.1 cm, with a median of 2.6 cm (± 3.6). The θim/θ values ranged from 0.36 to 0.88, with a median of 0.57 (± 0.098). The α values ranged from 0.002 to 0.12 h-1, with a median of 0.034 h-1 (± 0.027). The values of the hydraulic and chemical transport parameters were found to be comparable with values reported by studies conducted on nearby field locations on similar soil. Based on semivariogram analysis, the measured properties were not spatially correlated. Because the method required only 2 days to collect data it should prove useful for future studies that require extensive field measurements of hydraulic and chemical transport properties.

KW - Hydraulic conductivity

KW - Solute transport properties

KW - Spatial variability

UR - http://www.scopus.com/inward/record.url?scp=0036080484&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=0036080484&partnerID=8YFLogxK

U2 - 10.1097/00010694-200206000-00001

DO - 10.1097/00010694-200206000-00001

M3 - Article

VL - 167

SP - 353

EP - 368

JO - Soil Science

JF - Soil Science

SN - 0038-075X

IS - 6

ER -